POWER ELECTRONICS DEVICE MODULE. MODEL IBL-PE-27

This is a general-purpose power circuit development panel. This consists of six numbers of thyristors and three numbers of power diodes. Using these devices, one can assemble any combination of SCR power circuits. This unit requires an external SCR trigger circuit with proper conditioning for gate firing. This unit has three fuse holders. The AC power required for enabling the power devices must be routed through fuses as a protective measure for the circuit board components.

NOTE: The circuit developer must take adequate precautions while handling this board, as high voltages do exist when high voltage AC power is connected to this device circuit panel. For safety of the operator, it is necessary to have an external circuit breaker as part of AC power inlet connections.

Specifications:

• Thyristors used : 6 Nos.
• Power diodes : 3 Nos.
• Fuse protection : on 3 lines
• Terminals : 4mm colored terminals for each device
• Patch cords : 4mm banana patch cords required.

Thyristor:
The Thyristor used works on CLIP ASSEMBLY technology with
a) An average ON-State current of 10A @ 180? conduction angle.
b) Critical rate of rise of on-state current 50 A/ ?sec.
c) Peak gate current with 4A.
d) Average gate power dissipation 1 Watt.
e) Maximum peak reverse gate voltage 5 V.
f) Threshold voltage 0.77V.
g) Average gate power dissipation 1Watt.
h) Snubber circuit is connected across each thyristor.

Diode: 16Amps with PIV of

NOTE: Suitable External SCR trigger circuit required as per your circuit design. Alternately SCR TRIGGER APPLICATIONS TRAINER Model PE-14 can be used.